How to Test an Ice Maker Ejector Motor

It is important to remember that your ice maker may need to check every while. You will need to test the engine Pitcher to make sure it works correctly from time to time. This process is not difficult as long as you understand the steps to be taken.
Materials needed:

* Screwdriver
* Pen
* Needle nose pliers
* Test a multi-

Step 1: Prepare

You will need to prepare the first to undertake this task by unplugging the refrigerator. From there, it is usually easier to completely remove the ice maker compartment. You will need to remove the screws in order to do so.
Step 2: Remove the wire

You will need to remove the wires that connect to switch. Make sure that you do not pull on the wires the same as you do this. Usually it will a pair of needle nose pliers do the trick. Look at the link if worn at the time you will need to replace it.
Step 3: Test for Cars

Using multiple test, you will need to test the car out. You will need to adjust the X1. You are looking for continuity to be at 600 ohms. If the test multiple reads at zero or infinity, it needs to be replaced.


http://www.prohometips.com/ This site facilitate with home improvement,home repair,extreme home makeover,home improvement site,HGTV,DIY,do-it-yourself,buying guides,consumer reports ,Free home improvement advice, great remodeling tips, and appliance buying guides by leading home improvement authority, DIY expert and HGTV personality
For further details about ice maker visit our website: http://www.prohometips.com/